Smart Avi UDX-2P - Manual (Page 2)

up to 250 ft over STP
UDX-2P-TX UDX-2P-RX
USB 2.0 FLASH
DRIVE
USB 2.0 KEYBOARD USB 2.0 MOUSE
DVI-D MONITORS
COMPUTER
Introduction
The UDX-2P is the perfect solution for extending dual
DVI-D displays and USB 2.0 devices to a remote location.
It extends DVI-D and USB 2.0 signals to a remote location
up to 250 feet away. The UDX-2P features pixel accurate
signal reclocking which regenerates the input signal into a
perfectly sharp and clear output signal. It is fully plug and
play with dynamic DDC learning.
Connecting the UDX-2P
1. Power off all devices.
2. Connect two DVI-D sources (computer) to the
DVI-D ports of the UDX-2P-TX
labeled DVI-D IN 1 and DVI-D IN 2 .
3. Connect a USB source to the USB port of the the
UDX-2P-TX labeled
4. Connect the UDX-2P-TX to the the UDX-2P-RX with
three STP (Sheilded Twisted Pair) cables using the
ports labeled from TX to RX, TX
to RX, TX to RX.
5. Connect the DVI displays to the port on the rear of
the UDX-2P-RX labeled DVI-D IN 1 and DVI-D IN 2.
6. Connect up to 4 USB 2.0 devices to the ports on
the UDX-2P-RX labeled
7. Connect the power supply to the ports labeled
on the UDX-2P-TX and UDX-2P-RX.
8. Power on the computer, displays and USB 2.0
devices.
Applications
• Medical Applications
• Industrial Work Areas
• Home Theater Integration
• Digital Signage Deployment
• Information Kiosks/Displays
• Film/Recording Studios
Features
• DDC from internal table for Mac/PC
• Dedicated switch to learn any DDC
• Supports High Resolution 1920x1200 60Hz
WUXGA
• Supports Mac, PC, and Linux DVI
• Uses universal DVI Single Link connectors
• Zero pixel loss with TMDS signal correction
• Supports all USB 2.0 and 1.0 Devices
Transparently
(Disk Drives, Flash Drives, Printers, Cameras,
Scanners, etc.)
• Supports 4-port USB 2.0 in remote location
• Full reclocking for the receiver regenerates
digital signal producing top signal quality
• Extends up to 250ft (275ft with high quality
CAT6 STP)
Product - Installation Diagram
1 1 2
2 3 3
The following is the wiring standard for terminating UTP/STP
cable using RJ-45-STP connector:
Connectors: RJ-45-STP
Capacitance: 14 pf/ft (46.2 pf/m)
Conductor Gauge: 24 AWG
Impedance: 100 +/- 15 ohms
Pair 1 Pins 1 & 2
Pair 2 Pins 3 & 6
Pair 3 Pins 4 & 5
Pair 4 Pins 7 & 8
Learning the EDID of a Display
1. Power off all devices.
2. Power on the UDX-2P Transmitter and the display
to be learned.
3. Connect a DVI-D display to the DVI-D port of the
UDX-2P transmitter labeled DVI-D IN .
4. Press the LEARN button
5. The light will blink quickly if the learning was
successful. If the learning is unsuccessful the light
will not illuminate.