beautypg.com

Product - installation diagram, Introduction, Connecting the udx-plus – Smart Avi UDX-Plus User Manual

Page 2: Learning the edid of a display, Applications, Features

background image

up to 250 ft over STP

UDX-Plus-TX

UDX-Plus-RX

USB 2.0 FLASH

DRIVE

USB 2.0 KEYBOARD

USB 2.0 MOUSE

DVI-D MONITORS

COMPUTER

Introduction

The UDX-Plus is the perfect solution for extending dual

DVI-D displays and USB 2.0 devices to a remote location.

It extends DVI-D and USB 2.0 signals to a remote location

up to 250 feet away. The UDX-Plus features pixel accurate

signal reclocking which regenerates the input signal into a

perfectly sharp and clear output signal. It is fully plug and

play with dynamic DDC learning.

Connecting the UDX-Plus

1. Power off all devices.

2. Connect a DVI-D source (computer) to the DVI-D

port of the UDX-Plus-TX

labeled DVI-D IN .

3. Connect a USB source to the USB port of the the

UDX-Plus-TX labeled USB IN.

4. Connect the UDX-Plus-TX to the the UDX-Plus-RX

with two STP (Sheilded Twisted Pair) cables using

the ports labeled from TX to RX,

and TX to RX.

5. Connect the DVI display to the port on the rear of

the UDX-Plus-RX labeled DVI-D IN.

6. Connect up to 4 USB 2.0 devices to the ports on

the UDX-Plus-RX labeled USB IN.

7. Connect the power supply to the ports labeled

on the UDX-Plus-TX and UDX-Plus-RX.

8. Power on the computer, display and USB 2.0

devices.

Learning the EDID of a Display

1. Power off all devices.

2. Power on the UDX-Plus Transmitter and the

display to be learned.

3. Connect a DVI-D display to the DVI-D port of the

UDX-Plus-TX labeled DVI-D IN .

4. Press the LEARN button

5. The light will blink quickly if the learning was

successful. If the learning is unsuccessful the light

will not illuminate.

Applications

Medical Applications

Industrial Work Areas

Home Theater Integration

Digital Signage Deployment

Information Kiosks/Displays

Film/Recording Studios

Features

DDC from internal table for Mac/PC

Dedicated switch to learn any DDC

Supports High Resolution 1920x1200 60Hz

WUXGA

Supports Mac, PC, and Linux DVI

Uses universal DVI Single Link connectors

Zero pixel loss with TMDS signal correction

Supports all USB 2.0 and 1.0 Devices

Transparently

(Disk Drives, Flash Drives, Printers, Cameras,

Scanners, etc.)

Supports 4-port USB 2.0 in remote location

Full reclocking for the receiver regenerates

digital signal producing top signal quality

Extends up to 250ft (275ft with high quality

CAT6 STP)

Product - Installation Diagram

1

1

2

2

The following is the wiring standard for terminating UTP/STP

cable using RJ-45-STP connector:

Connectors: RJ-45-STP

Capacitance:

14 pf/ft (46.2 pf/m)

Conductor Gauge:

24 AWG

Impedance:

100 +/- 15 ohms

Pair 1

Pins 1 & 2

Pair 2

Pins 3 & 6

Pair 3

Pins 4 & 5

Pair 4

Pins 7 & 8