Dymo 450 TWIN TURBO - Manual (Page 6)

4
3. Connecting your LabelWriter Printer
NOTE Do not connect the printer to your computer until after the
software installation is complete.
To connect the power
1 Plug the power cord into the power adapter. See Figure 3.
2 Plug the power adapter into the power connector on the bottom of
the printer. See Figure 4.
3 Plug the other end of the power cord into a power outlet.
4 Plug the USB cable into the USB port on the bottom of the printer.
5 Insert the power and USB cables through the cable channel and set
the printer down.
6 When the software is completely installed, connect the other end of
the USB cable into an available USB port on your computer.
Mac OS If the printer is not in the printer list when the installation is
complete, refer to the ReadMe file for instructions on how to add
the printer.
Figure 3
Power adapter
Power cord
Figure 4
Power
Cable
channels
USB