Sierra Video ADA-108 - Manual (Page 13)

SIERRA VIDEO
7
Installation
Introduction
Installation procedures are similar for all modules covered under this manual. Exceptions,
if any, have been noted in each of the following paragraphs.
Module Mounting
Carefully inspect the module to ensure that there has been no shipping damage. Make
sure all shipping material is removed from the module and frame.
Install the module in any available slot in the frame with the ejector tab towards the
bottom. Lock the module in place with the ejector tab.
Rear I/O Panel
OG-ADA-10
The 10 slot frame uses a single I/O module: OG-ADA-10
Each board using this I/O has 10 BNCs available and are used to provide a looping input
1x8 DA.
Note:
The 20 slot frame can use two different I/O modules: OG-ADA-21 or the OG-ADA-22.
OG-ADA-21
The OG-ADA-21 operates just like the 10 slot frame I/O module with 10 BNCs per DA
board. The board supports 1 ADA-108 module.
A single I/O module will consume two of the 20 slots and only accept one DA board.
Chapter 2