Delta DT2400CS - Manual (Page 16)

16- ENG D27918
4. Connect water source to pump inlet.
NOTE: Water source must provide a minimum of 5
gallons per minute at 20 p.s.i.
5. Connect high pressure hose to pump outlet.
6. If applying a cleaning solution, see How To Use
the Dual Cleaning Solution System in Operation
section of this manual.
7. Turn water source on.
8. Start engine. See Engine Owners Manual for
correct procedure. NOTE: If the engine does not
start after two pulls, pull the trigger to relieve the pressure.
9. Depress trigger on gun to start water flow. NOTE: Stand on a stable
surface and grip gun/wand firmly with both hands. Expect the gun to
kickback when triggered.
10. Release trigger to stop water flow.
11. Adjust nozzle spray for the task being performed. See How To Use Wand
instructions in this section.
SHUTTING DOWN
1. After use of cleaning solution the chemical injector MUST be rinsed in order
to prevent pump damage caused by solution build up. The warranty will not
cover pumps that are damaged because the chemical injector was not properly
rinsed.
To rinse chemical injector using chemical injector hose
a.
Remove cleaning solution hose from chemical injector barb fitting.
b. Push chemical injector rinsing hose onto the chemical injector barbed
fitting.
c. Place other end of chemical injector rinsing hose into container of clean
water and depress trigger to draw at least one gallon of clean water through
chemical injection system to rinse system thoroughly.
Water
Source
High
Pressure
Hose
Hook-up