Parameter storage, Parameter recall, Specifications – Sierra Video 587135-00 User Manual
Page 5

Table 2: Color Bar Y, Cb, Cr Values and Their Corresponding Switch Settings
Switch B Settings in Hexadecimal
Color Y Cb Cr swA= 9 8 7 6 5 4
White
940
0
0
E B
0 0
0 0
Black
64
0
0
1 0
0 0
0 0
Yellow (100%) 840
-448
73
D 2
9 0
1 2
Cyan
"
678
151
-448
A 9
2 5
9 0
Green
"
578
-297
-375
9 0
B 6
A 3
Magenta "
426
297
375
6 A
4 A
5 D
Red
"
260
-151
448
4 1
D B
7 0
Blue
"
164
448
-73
2 9
7 0
E E
Yellow (75%)
646
-336
55
A 1
A C
0 D
Cyan
"
525
113
-336
8 3
1 C
A C
Green
"
450
-223
-281
7 0
C 9
B A
Magenta "
335
223
281
5 3
3 7
4 6
Red
"
260
-113
336
4 1
E 4
5 4
Blue
"
139
336
-55
2 2
5 4
F 3
Parameter Storage
The current parameter settings can be stored to one of seven EEPROM registers for the present video
standard by setting SWA to position E and setting SWB to any value from 1 to 7. The storage to EEPROM
occurs when SWA is then moved OUT of position E. If SWB is set to any value except 1-7, moving SWA
out of position E will NOT result in parameter storage to EEPROM. Note that separate storage locations
exist for 625 and 525 line parameters (7 for each). 7 locations are also reserved for 270Mbps streams
which cannot be identified as 525 or 625 line signals (for compatibility with future 270Mbit streams).
Parameter Recall
Stored parameter settings can be recalled from one of seven EEPROM registers for the present video
standard by setting SWA to position F and setting SWB to any value from 1 to 7. As SWB is changed, the
the settings are recalled from the corresponding EEPROM register. On power up the module automatically
configures the module to the settings in effect when power was lost.
Specifications
Video Input Standard
SMPTE 259M
Video Input Connector
BNC female
Video Input Return Loss
>15dB @ 270MHz(75 Ohm referenced)
Video Input Range
Source must be within 200 meters of input when using Belden 8281
or equiv.
Video Output Standard
`
SMPTE 259M
Video Output Connector
BNC female
Video Output Jitter
<350 picoseconds peak-to-peak with 10 Hz high pass filter
Power Consumption
5V, <1.5A
8V, <0.5A
-8V, <0.15A
Operating Temperature Range
0 to 50 C, non-condensing
Operating Humidity Range
0 to 95% RH
Skirt Generator User’s Guide
5