Sierra Video SCP-20 - Manual (Page 14)

SIERRA VIDEO
8
DIP switch settings
Your control panel has been configured at the factory for the settings you are most likely to need.
However, if you want to configure the control panel differently, you can do so by setting the
switches located on the processor board.
The SCP panels have 2 DIP switches that set the panel’s ID number, type, baud rate, and
memory settings. The panel is shipped with the factory defaults as indicated in the table below. ID
numbers are randomly set at the factory. If you need to change any values, follow the table
below.
Disconnect the panel’s power and remove the cover to access
the DIP switches. The table below shows the settings available:
Note:
Changing any Dip Switch causes an automatic reset after a few seconds
Each panel in a system MUST have its own unique ID number.
.
!
Control Panel
Dip Switch Settings Label (LB04152-00)
804112/804224 Select (S1-2):
804112 panel: S1-2 off
804224 panel: S1-2 on
804020 panel: S1-2 off *
804132 panel S1-2 off
Port speed (S1-6):
9,600 bps S1-6 off
31,250 bps S1-6 on *
Firmware Download (S1-7):
Normal Operation: S1-7 off *
Force Wait for Download: S1-7 on
Flash Memory Erase (S1-8):
Normal Operation: S1-8 off *
Erase Flash Memory: S1-8 on
Panel Id (S2-1 to S2-7):
Id 0 7 off 6 off 5 off 4 off 3 off 2 off 1 off
Id 1 7 off 6 off 5 off 4 off 3 off 2 off 1 on
Id 2 7 off 6 off 5 off 4 off 3 off 2 on 1 off
Id 3 7 off 6 off 5 off 4 off 3 off 2 on 1 on
Id 4 7 off 6 off 5 off 4 off 3 on 2 off 1 off
Id 5 7 off 6 off 5 off 4 off 3 on 2 off 1 on
(etc.)
Id 62 7 off 6 on 5 on 4 on 3 on 2 on 1 off
Id 63 7 off 6 on 5 on 4 on 3 on 2 on 1 on
(etc.)
Id 99 7 on 6 on 5 off 4 off 3 off 2 on 1 on
* Factory Settings