Sensoray 512 - Manual (Page 6)

6
4. Hardware Configuration
The 512 is installed on a PC/104 stack. Four mounting holes are provided, one in each corner, for
mechanical stability. The bus connectors are the large ones as seen on the bottom of figure 1.
The base address of the 512 must be selected using the base address selection jumper, as seen in the
lower left hand corner of figure 1. Address selection will be discussed in a following section.
Video, audio, and digital I/O are present on five connectors. The header, J1, has all I/O signals, including
S-Video, composite video, audio, and digital. J27, J28 are for composite video only and J26, J26 are for
audio only.
J27
J28
J26
J25
J1
BASE
ADDRESS
SELECTOR
Figure 1 Board Layout