Sensoray 512 DOS - Manual (Page 6)

6
4. Hardware Installation
The 512 is installed on a PC/104 stack. Four mounting holes are provided, one in each corner,
for mechanical stability. The bus connector are the large ones as seen on the bottom of
figure 1.
This base address of the 512 must be selected using the base address selection jumper, as
seen in the lower left hand corner of figure 1. Address selection will be discussed in a following
section.
Video and digital I/O are present on five connectors. The header, J2, has all I/O signals,
including Svideo, composite video, and digital. J1, J3 are for composite video only.
J1
J3
J2
BASE
ADDRESS
SELECTOR
Figure 1 Board Layout