Sea Eagle Rowing Frame / Sliding Seat for PaddleSki - Manual (Page 2)

Instructions on how to attach the oars to the rowing arm is
explained in the instructions for the Sliding Seat.
B) Sliding Seat Configuration
Place the sliding seat on the preassembled frame. Then secure
the sliding seat to the preassembled frame with 4 large black
knurled nuts (a) and 4 large washers (b) as shown below.
Attach the sliding seat cushion to the the sliding board for
comfort during rowing.
Place the assembled Sliding Seat on your PaddleSki between
the middle and the aft yoke. The rowing arm should lie towards
the stern. The assembled sliding seat must touch the middle
yoke as shown to prevent movement of the frame while
rowing. Loop the included foot strap around the bolts of the
aft yoke to lock your feet while rowing.
Now snap the collapsible oars together, attach the oarlock pins
with bolts and wing nuts. Now drop the oarlock pins in the
fittings on the two end of the rowing arm as shown.
Fully assembled Sliding Seat configuration looks like this:
19 North Columbia Street, Suite 1
Port Jefferson, NY 11777
e-mail: [email protected]
Ph: (800) 748-8066