Sea Eagle Transom Sport Boats & 8.10yt Yacht Tender (10.6SRY, 10.6SR, 12.6SR, 14SR) - Manual (Page 8)

Place the floor inside of
the boat with the air
valve located in the bow
of the boat, facing up.
Begin inflating the floor
using the high volume
setting on the A-50.
When resistance is met
switch over to the high
pressure setting and fin-
ish inflating the floor
until resistance is met.
Position the floor for the
10.6SR so that it is lo-
cated just behind the air
valve for the outside
drop stitch keel. Inflate
the floor first and the
keel second. Once the
floor is inflated set the
A-50 back to the high
volume setting and fin-
ish inflating the main
chambers on the hull.
Plastic Floorboards
Our Sport Runabouts
feature an interlocking
polyethylene floorboard
which are high strength
and maintenance free.
The top of these boards
are textured for traction.
The underside of these
boards are smoothed
and numbered.
If you have either the
12.6SR or 14SR than
you will need to attach
the reinforcement kit to
floorboards marked FB-
2 and FB-4 before you
install the floorboards
into the boat. This is a
one-time only assembly.
The FB-2 has two
threaded brass inserts
for the reinforcement
board and four others
for (optional) steering
console. Secure the
board to the smoothed
underside of the FB-2
using the screws and
washers. Use a Phillips
head screwdriver to
tighten the screws.
Locate and attach the
two reinforcement bars
to the traction (top) side
of the FB-4 using the
threaded brass inserts
and the knurled knobs.
The reinforcement kit
lends additional support
to the transom for better
performance with high
powered gas engines.
Each of our Sea Eagle
Sport Runabouts utilize
different floorboard
pieces and stringers al-
though the assembly for
them remains the same.
10.6SR
FB-1, FB-2, FB-3 (short) & FB-4
Qty 2. STR80 Stringer (80 cm/31.5”)
Qty 2: STR45 Stringer (45 cm/17.71”)
12.6SR
FB-1, FB-2, FB-3 & FB-4
Qty 2. STR124 Stringer (124 cm/49”)
Qty 2: STR37 Stringer (37 cm/14.5”)
14SR
FB-1, FB-2, FB-3, FB-3 (short) & FB-4
Qty 2. STR14L Stringer (124 cm/49”)
Qty 2: STR14S Stringer (80 cm/31.5”)
Sea Eagle’s floorboard and stringer system is designed to
be snug inside the boat. Although installation can be done
by one person, it also requires some patience and practice.
Use the tips provided to make the job easier.
7