DOD Bass30 User Manual

Page 32

Rotate the Data Wheel until the Display shows

0. Press the Tone/Gate button again and the LED next to Low Mid

flashes. Rotate the Data Wheel until the Display shows

0.Press the Tone/Gate button again and the Bass LED will

flash. Rotate the Data Wheel until the Display shows

6. Press the Tone/Gate button one more time and the Gate

LED flashes. Rotate the Data Wheel until the Display shows

Step 6 Select the Chorus Effect -

Press the Effect button until the LED next to Chorus is flashing. If the Chorus

is bypassed (indicated by two dashes

-- in the Display), rotate the Data Wheel until the Display shows on.

You will notice that the Parameter LEDs next to the words “Speed,” “Depth,” and “Level” are now lit. This
indicates that these three Parameters are associated with the Chorus, and available for adjustment. Press the
Parameter Edit button once and the Speed LED will begin to flash indicating that you are about to edit the Chorus
Speed. The Display will show the current value for the Chorus Speed. Since our sample Preset calls for a slow
medium Chorus, use the Data Wheel to set the Speed value to

5. Press the Parameter button again and the Depth

LED flashes. Rotate the Data Wheel until the Display shows

10. Press the Parameter button again and the Level

LED flashes. Rotate the Data Wheel until the Display shows

50.