DeLonghi EW0507W - Manual (Page 6)

To cancel a preset aprogramme, press the timer button A or B once and then press
the hour button until the display shows “--:--“ (fig.6).
TIMER OVERRIDE
To operate the appliance without using the programmes (timer), press the “ON
MODE” button (Fig.5). The yellow lamp will go off.
IMPORTANT:
If the heater looses its electricity supply for more than 2 minutes the appliance does
not switch on. The display shows the blinking numbers.
To switch it on, repeat the above described operations.
WARNINGS
You must leave the heater plugged in at the mains socket to keep the heaters memory
programmed.
If the heater looses its electricity supply for more than 2 minutes, e.g. switched off at
the mains socket or in the event of a power failure, the heater’s programmes will be
lost, and the heater will not work until reset.
A safety device switches the heater off in the event of overheating. To restart the
heater, call the nearest Service Center to change the safety device.
Note: when the safety device intervenes, the heater doesn’t heat but the display
regularly works.
4. MAINTENANCE AND SERVICE
Always remove the plug from the power socket and allow the radiator to cool. Wipe
radiator with a soft damp cloth, do not use detergents and abrasives.
Should the radiator not be in use over a certain length of time, wind the cable round
the holder and store it in a dry place.
This appliance has been built to give many years of trouble free service.
In case of malfunction or doubt, do not try to repair the heater by yourself: it may
result in fire hazard or electric shock.
Call the nearest Service Center (see attached list of Service Centers).
6
AUTO
:
fig. 6
GB 23-03-2004 16:21 Pagina 6