Dodge 2004 PL Neon - Manual (Page 54)

Compass Calibration
If “CAL” is not displayed, press and hold the “Left”
button for 10–15 seconds, or until “CAL” appears in the
display, then release the button. The compass is now in
calibration mode.
The mirror can be calibrated in one of two ways
• Drive the vehicle in circles at less then 5mph (8 km/h)
until “CAL” no longer appears in the display.
• Drive the vehicle under normal operating conditions.
Outside Mirror — Driver’s Side
Adjust the outside mirror to center on the adjacent lane of
traffic, with a slight overlap of the view obtained on the
inside mirror.
Outside Mirror — Passenger’s Side
Adjust the convex outside mirror so you can just see the
side of your vehicle in the part of the mirror closest to the
vehicle.
WARNING!
Vehicles and other objects seen in the passenger side
convex mirror will look smaller and farther away
than they really are. Relying too much on your
passenger side mirror could cause you to collide
with another vehicle or other object. Use your inside
mirror when judging the size or distance of a vehicle
seen in this convex mirror.
Electric Remote-Control Mirrors — If Equipped
Use the mirror select switch, located on the drivers door
trim panel, to adjust the view obtained in the outside
mirrors. Press the rocker knob to the L or R for Left or
Right mirror selection. Use the center off position to
guard against accidentally moving a mirror position.
54 UNDERSTANDING THE FEATURES OF YOUR VEHICLE