DeLonghi 50EDDE - Manual (Page 5)

6
ELECTRONIC MODEL
O
N/OFF button
Press this button to start /stop the appliance. The compressor will respond to the modified
humidity setting 3 minutes after the unit is switched on.
M
ODE button
Press this button to select the Fan only or Dehumidifier modes.
R
oom temperature knob
Press this button to display the Temperature or Humidity reading on the LCD display.
If you press the button once the display will show the °F . If you press the button twice, the
display will show the temperature in °C. After few seconds, the display will automatically
show the humidity level.
F
AN button
Press this button to select the High Fan Speed or Low Fan Speed settings.,
Press this button to increase the humidity level by 5% up to a limit of 80%RH.
Press this button to reduce the humidity level by 5%up to a limit of 30%RH. When the unit is
in continuous operation the LCD screen will display two dashes.
NOTE: If the set humidity level is higher than the level in the room, the compressor will stop
working, although the fan continues.
The default humidity setting is 60%RH
C o n t r o l p a n e l
Display
FAN
button
ON/OFF
button
MODE button
Room
temperature
knob
°F/ °C
Full Tank light
Operation
Increase humidity
level button
Decrease
humidity level
button
GB 12-12-2003 16:15 Pagina 6