Royal Vacuums CH53005 - Manual (Page 10)

10
BRusHRoll
: How to Clean
4.8 Turn vacuum over so bottom side is facing up.
Rotate red upper latch (A) counterclockwise.
4.9 Slide red lower latch (B) to the unlock position.
4.10 Pivot out bottom plate and remove any debris
and/or hair from brushroll.
Reposition bottom plate, aligning tabs along front
edge of nozzle guard with slots in nozzle. Rotate
back into position. Slide red lower latch to Lock
position, and rotate red upper latch clockwise.
4.8 4.9
A
B
4.10
CAUTION
! !
To reduce the risk of injury from moving parts,
Unplug before servicing.
FilteRs:
How to Clean
secondary Filter
4.6 The secondary filter (A) protects the motor from
dirt particles.
If filter becomes dirty, pull off grill and lift out filter.
Hand wash filter in cold water. Let filter air dry for 24
hours. Reposition dry filter and grill.
CAUTION
! !
To reduce the risk of injury from moving parts,
Unplug vacuum before servicing.
Do not operate cleaner without either the
secondary or final filter in place.
what to Buy: secondary Filter
Use only genuine HOOVER ® Secondary Filter
with your vacuum. When purchasing a new
Secondary Filter, ask for HOOVER ® Part No.
902417001.
Final Filter
The final filter assists in the filtration process to
return clean air to the room.
4.7 To remove the filter, pull tab on filter holder down
and remove filter.
Lift out filter (B) and hand wash it in cold water.
Let filter air dry for 24 hours and reposition it on the
side of the filter holder and push filter holder back
into cleaner.
what to Buy: Final Filter
Use only genuine HOOVER ® Final Filter with
your vacuum. When purchasing a new Final
Filter, ask for HOOVER ® Part No. 902418001.
4.7
B
IMPORTANT
Allow filter to dry completely before replacing.
Dry filter on edge so air circulates on both sides
of filter. This may take up to 24 hours.
4.6
A
Actual model may vary from images shown.