RF Neulink NL900 - Manual (Page 10)

NL900 User’s Manual
August 2013 10
1.4.3 Programming
Programming is accomplished with the following procedure:
1. Connect a NL900 unit to a serial communications port on your computer.
2. Connect the power supply to the NL900 unit. Make sure the Pwr LED is on.
3. Start the NL900 Configuration Utility.
4. Select the COM Port that is connected to the NL900 unit.
5. Select the Baud Rate of the NL900 unit. All NL900 units are shipped with a default rate
of 57600 (unless units have been preconfigured to match specific serial settings). If the
Baud Rate of the NL900 unit is changed as described below in Section 1.4.5 Changing
NL900 Settings, then this setting must be set to the same Baud Rate to allow proper
programming of the units.
6. Select the System Configuration for the NL900 network, Point-to-Point (one Server and
one Client) or Point-to-Multipoint (one Server and multiple Clients).
7. Select Read Radio to display the current settings of the NL900 unit.
8. Change desired settings.
9. After all changes have been made, select Write Radio to save the changes.
10. Cycle Power to the unit after all changes have been saved. This will set the
NL900 unit to its normal mode of operation.