Dixon 115 338927R1 - Manual (Page 13)

sAFetY
13
8011-516
Never fill the fuel tank indoors
Safe Handling of Gasoline
To avoid personal injury or property damage, use
extreme care in handling gasoline. Gasoline is
extremely flammable and the vapors are explosive.
Extinguish all cigarettes, cigars, pipes, and other •
sources of ignition.
Use only approved gasoline container.
•
Never remove gas cap or add fuel with the engine •
running. Allow engine to cool at least two (2)
minutes before refueling.
Never fuel the machine indoors.
•
Never store the machine or fuel container where •
there is an open flame, spark, or pilot light such
as on a water heater or other appliance.
Before beginning to refuel, minimize the risk of
•
static electricity by touching a metal surface.
Never fill containers inside a vehicle or on a truck
•
or trailer bed with plastic liner. Always place
containers on the ground away from the vehicle
when filling.
Remove gas-powered equipment from the truck
•
or trailer and refuel it on the ground. If this is not
possible, refuel such equipment with a portable
container, rather than from a gasoline dispenser
nozzle.
Keep the nozzle in contact with the rim of the fuel
•
tank or container opening at all times until fueling
is complete. Do not use a nozzle lock-open
device.
If fuel is spilled on clothing, change clothing
•
immediately.
Never overfill fuel tank. Replace gas cap and
•
tighten securely.
Do not start the engine near spilled fuel.
•
Never use gasoline as a cleaning agent. •
If leaks arise in fuel system, engine must not be •
started until problem has been resolved.
Check the fuel level before each use and leave
•
space for the fuel to expand, as the heat from the
engine and the sun may otherwise cause the fuel
to expand and overflow.
WARNING!
The engine must not be started when the driver’s floor plate or any protective plate for the
mower deck’s drive belt is removed.
WARNING!
The engine and the exhaust system
become very hot during operation.
There is risk for burns if touched.
Allow engine and exhaust system to
cool at least two (2) minutes before
refueling.