DVDO VS4 - Manual (Page 3)

2
INSTALLATION AND SETUP
The VS4 package contains the VS4 switch unit, a power supply and two infrared
remote control units.
Remove and unwrap the components from the package. The infrared remote con-
trols each contain a clear plastic battery protection tab. This tab must be removed
from the remote control units before use.
Connect the power supply to the VS4 unit as shown in the picture below.
Plug the power supply into a power outlet.
Connect HDMI cables (not included) from the HDMI or DVI source(s) to the VS4
inputs.
Connect an HDMI cable from the VS4 output to an HDMI or DVI display or to an-
other HDMI receiving device, such as an AV receiver.