REMKO MKT 240 - Manual (Page 8)

MKT 240
8
CAUTION
■ The function of the device was precisely
checked several times at the factory. If
malfunctions that are not described in
the “Trouble Shooting“ chapter (s. p.
7) still appear, contact your dealer or
contractual partner.
■ In order for REMKO to assume the
warranty, the “Warranty Certifi cate“
included in delivery must be completely
fi lled out and sent to REMKO GmbH &
CO KG immediately after purchasing or
commissioning.
Warranty
Electrical wiring diagram
The manufacturer is not li-
able for damage that occurs
due to nonobservance of
manufacturer instructions or
the legal requirements or due
to unauthorised changes to
the device.
Fig. 18 Electrical wiring diagram
Technical dimensions and design sub-
ject to alteration
Evaporator fan
Condenser
Red
Orange
Yellow
White W W
Red
Red
Red
Blue Blue Blue Blue
Condenser Condenser
Compressor Evaporator fan Reservoir motor
Mains plug
White
Blue
White
Blu
e
Microswitch
Temperature
sensor
J003
J00
2
J00
1
Hi Med Lo
L N
E
Brown
COMP
To take the device out of service,
deactivate it fi rst by pressing the “Power“
button. Then pull the mains plug.
If the device must be shut down for a
longer period of time, for example, for
storage during the winter, observe the
following:
1.
Let the machine run for about two
hours in the “Fan“ mode to dry the sur-
face of the evaporator plate fi ns. In this
way, the residual moisture is removed
from the device and you can prevent
unpleasant smells during recommission-
ing.
2. Switch off the device, pull the mains
plug, and roll up the mains supply line.
3. Drain the condensate (s. p. 6).
Taking out of service