Relacart Electronics PM-160 - Manual (Page 4)

P5 P6
03
1 3 4 5 2
1 2 3 4 5 6
Transmitter Controls and Functions
Figure A: PM-160 Transmitter Front Panel
①Power Switch：Press power switch in 3 seconds and the transmitter readouts will light.
②Monitor: Earphone output jack.
③ LCD Window: Liquid Crystal Display indicates control setting and operational readings. See
“System setup” on page 10 for details.
④ ⑥ UP / DOWN Buttons: Press Up or Down arrow button, in conjunction with the Set button, to step
through menus, select operating frequency and edit transmitter function choices.
⑤ SET Button: Use in conjunction with the Up / Down arrow buttons to step through menus, choose
operating frequency and select transmitter function options.
Figure B: PM-160 Transmitter Rear Panel
①Antenna Input Jack: BNC type antenna connector, attached the antenna directly.
②RF POWER Output: Two-position switch adjusts RF power output, with LOW of 30mW, HIGH of
100mW.
③1/L Unbalance LOOP OUT output jack: Unbalanced 1/4” (6.3mm) phone jack to be connected to
another PM-160 transmitter's Balanced Input.
④2/R Unbalance LOOP OUT output jack: Unbalanced 1/4” (6.3mm) phone jack to be connected to
another PM-160 transmitter's Balanced Input.
⑤1/L Balanced Input Jack: XLR type connector. A standard 2 conductor shielded cable can be used to
connect the transmitter input to a balanced output on a mixer or integrated amplifier.
⑥2/R Balanced Input Jack: XLR type connector. A standard 2 conductor shielded cable can be used to
connect the transmitter input to a balanced output on a mixer or integrated amplifier.
⑦DC Power Output Jack: 12V / 500mA.
6 7