Posiflex MR-2106 - Manual (Page 2)

Page 2 / 2
IV. CABLE CONNECTION GUIDE
Cable connection for KB WEDGE models
Cable connection for RS232 interface models
Cable connection for USB interface models
V. ADJUSTABLE PARAMETERS
Some parameters in readout format of the MR2100/MR2200 series in PS/2 KB interface and USB
interface can be controlled by software downloaded from our web site: http://www.posiflex.com.
However, PS/2 and USB model are automatically saved parameters even after power off and on. It is also
possible to adjust some parameters with modification in hardware described below if not by software.
Please note that the individual track enable mentioned applies only when the track is supported in
physical reader head.
For ISO & JIS2 in USB Mode Jumper Setting
(1). P2 : Connected to USB Cable
(2). CN3 : ISP(Update MCU Firmware)
(3). CN4 / CN5 : ISO Magnetic Stripe Reader
(Use in "USB KB mode" or HID mode")
(4). CN4 / CN5 : JIS2 Magnetic Stripe Reader
(Only use in "USB KB mode")
Jumper Setting:
Jumper
Position
J1 J2 J3 J4
Function ALT-Num NumLock USB Class Boot protocol
Opened Enable
Send Numlock Key
Code
Vendor Class for Linux
or WinCE
Boot protocol for DOS
6.22
Closed Disable N/A HID Class for Windows
Non-Boot protocol for
Windows
Default Close Close Close Close
For ISO in PS2 & RS232 Mode Jumper Setting
For RS232 Mode:
(1). P1 : Not connected.
(2). P2 : Cable Connected to MB(Com Port) &
Power: 5V.
(3). CN3 : ISP(Update MCU Firmware)
(4). CN4/CN5: ISO Magnetic Stripe Reader/JIS2
Jumper Setting:
Jumper J1 J2 J3 J4 J5 J6 JP1 JP2
Function Alt-Num Lead/
End Code
PS2/
RS232
Trk1 Trk2 Trk3 Header2x2
RS232
Header2x2
PS2
Opened Enable Enable PS2 Disable Disable Disable
Closed Disable Disable RS232 Enable Enable Enable
Default CLOSE CLOSE OPEN
Note: RS232 Mode must be closed J3, JP1; Opened JP2.
For PS2 Mode:
(1). P1 : Connected to PC(PS2-KB Port)
(2). P2 : Connected to Keyboard
(3). CN3: ISP (Update MCU Firmware)
(4). CN4/CN5: ISO Magnetic Stripe Reader
Jumper Setting:
Jumper J1 J2 J3 J4 J5 J6 JP1 JP2
Function Alt-Num Lead/
End Code
PS2/
RS232
Reserve Reserve PS2 Pin
Switch
Header2x2
RS232
Header2x2
PS2
Opened Enable Enable PS2
Closed Disable Disable RS232
Default OPEN OPEN OPEN CLOSE
Note: PS2 Mode must be opened J3, J6, JP1; closed JP2
MR2100/MR2200 PC
Keyboard
PC
Mini DIN 6 P Male Mini DIN 6 P Female KB I/P
PC USB port or USB hub MR2100/MR2200
MR2100/MR2200 2.5/5.5 DC plug from power adaptor
D sub 9 P Female
to COM port