POLAR Stride Sensor BT Smart - Manual (Page 6)

Pair a New Stride Sensor with Your
Receiving Device
Polar Stride Sensor Bluetooth ® Smart must be
paired with the receiving device in order to
analyze your running technique and efficiency.
For more information, see the user guidance
material of the receiving device or mobile
application.
Attach the Stride Sensor on Shoelaces
1. Undo your shoelaces and place the holder
on top of the tongue of the shoe. Make sure
the holder flap is facing upwards.
2. Thread the laces in through the holes on
the sides of the holder and out through the
hole on the bottom of the holder (pictures
C1 and C2). Thread the laces through the
small flap on the tongue of the shoe to
ensure the holder does not move while
running.
3. Tighten the laces.
4. Fit the front part of the sensor into the
holder and press from the rear (picture C3).
Fasten the flap.
5. Make sure the sensor does not move and is
aligned with your foot. The more secure the
sensor, the more accurately speed and
distance is measured.
4 E N G L I S H