Philco PHHB 6611 - Manual (Page 7)

5 Revison 06/2014 Copyright © 2014, Fast ČR, a. s.
EN
PART 4: HOW TO USE THE CHOPPING ATTACHMENT
The chopping attachment is suitable for chopping food, such as meat, hard cheese (e.g. Parmesan), vegetable
(e.g. onion, garlic, carrots etc.), herbs, nuts (e.g. hazelnuts, walnuts etc.), dried fruit (e.g. prunes) and other type
of food.
The chopping attachment has not been designed to cut ice cubes, spices (e.g. nutmug), coffee beans or similar
type of food.
Before inserting food into the bowl it is necessary to cut the food into small pieces.
Chopping attachment assembly:
1) Place a rubber non-slip pillow (12) onto the bottom of a chopper bowl. The rubber pillow prevent the
attachment from accidental shipping and tipping over and possible hurt.
2) Carefully insert a cutting knife (10) into the chopper bowl (11). Set the cutting knife onto the central spindle
of the bowl. Always hold the cutting knife by the plastic part.
CAUTION:
The cutting knife is very sharp!
3) Put the food you wish to chop into the bowl. The amount should not exceed the maximum limit (500 ml)
that is marked on the bowl.
4) Place a lid (9) on the bowl. The bowl should be put so that the pressing center, located on the underside of
the lid, is placed on the cross of the cutting knife as well as the security locks, located on the sides of the
lid, fi t into the bowl security system. Once the lid is placed correctly, turn the lid clock wise until it will not
be securely fi xed. The safe locking is indicated by a click.
5) To release the lid, turn the lid anticlock wise. The lid release is also indicated by a click. When releasing the
lid pay higher attention so that it will not tip over or release of cutting knife and possible hurt.
6) Place the motor unit (4) onto the assembled chopping attachment.
7) Now the device is ready to use. Insert the plug into the power outlet.
NOTE:
Use the device for no longer than 1 minute.
NOTE:
When assembling/disassembling the chopping attachment always make sure the device is switched off and
power cord is removed from the power outlet.
NOTE:
To disassemble, follow the opposite way.