Part 2: how to use your blender, Assembling the immersion blender – Philco PHHB 6601 User Manual

Page 6

Revison 06/2014

PART 2: HOW TO USE YOUR BLENDER

Remove all packaging materials. Attach the lower removable part to the motor unit.
Prior to initial use, it is necessary to thoroughly wash the device with hot water, using washing-up liquid,
followed by rinsing it with drinking water.
During washing and cleaning, you may submerge in water only the removable part 5. Do not submerge in
water or any other liquid the motor unit of the blender.

Assembling the immersion blender

1) Push the bottom removable part on to the motor unit (4) until it clicks in. A click indicates that the motor

unit is secured.

2) Now the immersion blender is ready for use. Connect the power plug of the appliance to a power socket.

NOTE:
Do not run the appliance for longer than 1 minute.
When assembling/disassembling the immersion blender, always make sure that the appliance is turned off
and disconnected from the power socket.

This manual is related to the following products:

PHHB 6600