Philco PHJE 5010 - Manual (Page 6)

4 Revision 05/2014 Copyright © 2014, Fast ČR, a. s.
EN
PART 3: INSTRUCTIONS FOR USE
Before fi rst use
1) Rinse all the parts that can be separated in lukewarm water and dry thoroughly.
2) Place the juicer on a stable non-slip even surface.
3) Connect the plug of the power cord to a suitable power socket (220-240 V).
Assembling the product
1) Insert the juice collector cup into the juicer as shown in the picture. Make sure that
the edge of the juice collector cup is level with the motor unit.
 
2) Place the stainless steel strainer into the juice collector cup. Make sure that the
strainer is fi rmly seated on the drive shaft. When seated correctly, the top edge of
the strainer should be under the level of the top edge of the juice collector cup.
 
3) Cover everything with the lid and push it down into the correct position.
 
4) Use one hand to push the lid downwards and at the same time tilt the locking arm
on to it so that the lid is secured in the correct position (you will hear a click).
 
 
5) Tilt the juicer slightly forward and place the pulp container into it - fi rst move the top end and then push
down the bottom end towards the juicer.
6) Now insert the plunger into the hopper. Notice that to make movement easier, the
hopper is equipped with a groove that fi ts together with the guide in the top part
of the hopper.
 