Philco PHWK 2002 - Manual (Page 8)

6 Revison 06/2014 Copyright © 2014, Fast ČR, a. s.
EN
PART 5: USING THE FAST BOIL KETTLE
A. Quick 100 °C boil
1. Plug the power cord into an electric socket. The connection of the kettle will be accompanied by a sound
and the display will be backlit and the water level mark (8) and control buttons (5) will be backlit for a short
time. The current temperature inside the kettle will be shown on the display.
2. Take the kettle off the base (9) and press the open lid button (3).
3. Fill with the required amount of water, close the lid and place the kettle back on to the base. Check that the
kettle lid is properly closed.
4. Press the quick boil button (1) to start the kettle, the pressed button and the water level mark will be lit.
5. As soon as the water in the kettle starts to boil, the heating of the water will automatically be stopped,
which will be accompanied by 5 sound signals. The backlit water volume indicator will turn off.
6. The current water temperature will be shown on the display.
7. The colour of the water level mark backlight changes during the course of the boil depending on the water
temperature (see table below).
Temperature °C Colour
20° Green
30° Green
40° Light blue
50° Light blue
60° Dark blue
70° Dark blue
80° Violet
90° Red
B. Heating water to a required temperature
Using this function you can set a specifi c temperature for the heated water.
1.
Fill the kettle with the required amount of drinking water.
2. Repeatedly press the temperature setting button (2) to set the desired water temperature (20, 30, 40, 50,
60,70, 80 or 90 ˚C), the pressed button and the water level mark of the kettle will be lit.
3. The current water temperature will be shown on the display together with the water temperature you set.
4. As soon as the water in the kettle reaches the preset temperature, the heating of the water will automatically
be stopped, which will be accompanied by a sound. The backlit water volume indicator will turn off.
NOTE:
It is not possible to use the heat water to desired temperature function to lower the temperature of the
water in the kettle. If you pour room temperature water at 25 °C into the kettle and set the target water
temperature to 20 °C, the kettle will not run in this mode.
C. Maintaining the set water temperature (KEEP WARM function)
NOTE:
The keep warm function can be used to maintain the water temperature of water heated to a desired
temperature or water boiled and subsequently cooled to the desired temperature. Both these methods
are described further on in this manual in points E and F.