Permasteel PS-206 User Manual
Page 2
ASSEMBLY INSTRUCTIONS:
TOOLS REQUIRED:
#2 Phillips screwdriver
Allen wrench
Please read the cooler manual carefully and assemble according to following steps.
1. Please make sure all parts are accounted for before beginning assembly.
2. Place main basin up-side down on clean soft surface insert each leg(part 10)
and rotate into main basin by hand, after 4 legs are installed, then put the
bottle tray on each leg, then rotate each wheel(parts 12&13) into the leg with
an open wrench
3. Turn over entire assembly right side-up press caster brake lever to lock casters
(part 12) insert right handle (part 5) into bracket attach using 6 pcs M6*12
Allen screws (parts 3) with a Allen wrench. Repeat for left handle.
4. Attach bottle-cap catcher (parts 9) to main basin by sliding it down over 2
preinstalled bolts,
5. Attach bottle opener (parts 7) to main basin using 2pcs M6*12 Allen screws
with a Allen screwdriver.
6.
Attach 2pcs lid handles (parts 1) to cooler lid by using 2pcs 5/32x1/2” screws
with a Philips screwdriver.
7.
Clean inside of cooler completely with soft dry towel. Place cooler lid (2) on top
of main basin (A) your cooler is now ready for use.