Permasteel PG-50506SRLA-SC - Manual (Page 18)

15
VERY IMPORTANT: ALWAYS INSPECT THE HOSE PRIOR TO EACH USE.
ƒ
BEFORE LIGHTING:
Inspect the gas supply hose before turning the gas “ON”. If there is evidence
of cuts, wear, or abrasion, it must be replaced before use. The replacement
hose assembly must be that specified by the manufacturer.
ƒ
VERY IMPORTANT: TO LIGHT MAIN BURNERS OF THE GRILL:
1) Read instructions before lighting.
2) Turn all knobs to “OFF” then open the LP tank valve. Always keep your face
and body as far from the grill as possible when lighting.
3) Open lid during lighting.
4) Push and turn any control knob slowly to “HI” position. The built-in igniter will
click and spark simultaneously to light the pilot and burner in sequence.Turn
the control knob to OFF IMMEDIATELY if the burner does not light within 5
seconds. Wait 5 minutes for gas to dispel, then repeat the lighting procedure.
5) Follow match lighting instructions if burner can’t be lit after repeating 3-4 times.
ƒ TO LIGHT THE MAIN BURNERS BY MATCH: (AS THE FOLLOWING FIGURE
SHOWS)
If the burner will not light after several attempts then the burner can be match lit.
Tools: Lighting rod (hanging behind the right door)
Usage:
1) Read instructions before lighting.
2) Open the lid during lighting.
3) Strike the match and place approximately 1/2” above lighting hole located on
right and left hand side of the grill body.
4) Push and turn the knob to “HI” position, make sure the burner lights and stays
lighted.
5) Repeat 3.4 to light other burners.
6) Keep a spray bottle of soapy water near the gas supply valve and check the
connections before each use. Do not light the grill if odor of gas is present, call
out service center at (888)-287-0735.
GRILL LIGHTING INSTRUCTION