Paslode CF325Li Li-ion Cordless Framing - Manual (Page 2)

2
Introduction and Warranty
Paslode Cordless Framing Nailer
Operating Manual
1. READ THE MANUAL FROM COVER TO COVER
BEFORE USING THE TOOL.
2. FOLLOW ALL INSTRUCTIONS IN THE MANUAL.
My Paslode representative is:
Name
Address
p i Z e t a t S y ti C
Telephone Number
Paslode ® Cordless CF325Li Warranty and Limitations
Paslode warranties that new Paslode Cordless power fastening
tools, parts and accessories will be free from defects in material
and workmanship for the period shown below, after the date of
delivery to the original user.
ONE-YEAR LIMITED WARRANTY
A one-year warranty will apply to all parts, except those listed
below as normal wearing parts, or parts which are specifically
covered by an extended warranty.
FIVE-YEAR EXTENDED LIMITED WARRANTY
A five-year warranty will apply to all molded nylon parts:
•
Motor Housing, Cap and Grille
• Handle Halves and Actuator
• Trigger
• Magazine Parts
WARRANTY STATEMENT
This warranty is limited to tools sold and service requested in the United
States. To obtain information on warranty service in the United States,
refer to the Service Center listing that was provided with your tool.
Paslode's sole liability hereunder will be to replace any part or accessory
which proves to be defective within the specific time period. Any replacement
part or accessory provided in accordance with this warranty will carry a
warranty for the balance of the period of warranty applicable to the part it
replaces. This warranty does not apply to part replacement required due to
normal wear.
This warranty is void as to any tool which has been subjected to misuse,
abuse, accidental or intentional damage, use with fasteners, fuel, batteries,
or battery chargers not meeting Paslode specification, size, or quality,
improperly maintained, repaired with other than genuine Paslode replacement
parts, damaged in transit or handling, or which, in Paslode's opinion, has
been altered or repaired in a way that affects or detracts from the performance
of the tool.
PASLODE MAKES NO WARRANTY, EXPRESSED OR IMPLIED, RELATING
TO MERCHANTABILITY, FITNESS, OR OTHERWISE, EXCEPT AS STATED
ABOVE, and Paslode's liability AS STATED ABOVE AND AS ASSUMED
ABOVE is in lieu of all other warranties arising out of, or in connection with,
the use and performance of the tool, except to the extent other wise provided
by applicable law. PASLODE SHALL IN NO EVENT BE LIABLE FOR ANY
DIRECT, INDIRECT, OR CONSEQUENTIAL DAMAGES, INCLUDING, BUT
NOT LIMITED TO, DAMAGES WHICH MAY ARISE FROM LOSS OF
ANTICIPATED PROFITS OR PRODUCTION, SPOILAGE OF MATERIALS,,
INCREASED COST OF OPERATION, OR OTHERWISE.
Paslode reserves the right to change specifications, equipment, or designs
at any time without notice and without incurring obligation.
This manual is intended to acquaint you with the
Paslode Cordless Framing Nailer. Unlike other power
fastening tools, the Cordless Framing Nailer is powered
by an internal combustion linear motor. In simpler
terms, your Cordless Framing Nailer is powered by a
motor similar to the one that powers an automobile. The
Cordless Framing Nailer ignites a fuel and air mixture to
produce the energy to drive the motor, which in turn
drives the fastener. As you will see, the Cordless Fram-
ing Nailer is totally self-contained. It carries its own fuel
supply and battery, along with a supply of fasteners.
For ease of use, this manual is divided into sections
(see Contents). Each section of the manual is written
with you, the tool operator, in mind. We have left out all
of the technical terms so that you can readily under-
stand how to get the maximum performance from your
Cordless Framing Nailer, and how to avoid damaging
the tool or injuring yourself. But, to accomplish this, we
need you to do two things:
The Cordless Framing Nailer should be handled like other
power fastening tools that you use. Like most tools, when
used improperly it could result in injury. If you are going to
allow others to use the Cordless Framing Nailer,it is your
responsibility to make sure that they also read and comply
with the instructions in this manual before attempting to
operate the tool.
Should you have questions about the Cordless Framing
Nailer, or wish to obtain additional copies of this
manual,please contact your Paslode
® representative. The
space below is provided so that you may record your
representative's name, address, and telephone number.
®