Paloma PHH-32 part 1 - Manual (Page 24)

24
Care Instructions
CARING FOR YOUR WATER HEATER
Problem Possible Cause Solution
Water not hot enough. 1. The temperature may be set too low. 1. Increase the temperature setting at
the remote control.
2.
The gas valve is not completely
opened.
2.
Check and completely open the gas
valve.
3. Gas supply pressure is low. 3. Contact your gas utility company or
gas contractor to verify the gas meter
and gas piping size.
4.
Bleed-over in one of the hot water
fixtures.
4.
Contact a dealer or a qualified service
technician.
Water too hot. 1. Temperature is set too high. 1. Decrease the temperature setting at
the remote control.
2. Water shut-off valve is not completely
opened.
2. Check and completely open the water
shut-off valve.
3.
Small amount of water has been
heated.
3.
Increase the hot water flow at the
faucet to allow more water to flow
through the water heater.
Fan continues to rotate after the hot water
faucet is closed. The post-purge cycle clears flue gases. Normal operation.
1
2
3
1
2
Troubleshooting Chart (cont.)