Directed Electronics RSS-2514XR - Manual (Page 6)

4
THE REMOTE CONTROL
Your remote control can transmit on two different channels, allowing control of two separate vehicles. Up to four remote
controls can be assigned to your vehicle.
NOTE: The range of your remote control can be affected by a weak battery, interference from
nearby metal structures, hydro poles, or crowded parking lots.
Only the "Panic" command is transmitted on both channels when a single command is sent
(alternating transmission channels).
The transmitter provides audible (piezo) and visual (LED
) confirmation.
The LED lights-up green when it transmits on channel one or red when it transmits on channel two.
The remote shown may differ from the one included in the kits.
SELECTING TRANSMISSION CHANNEL
CHANNEL 1 CHANNEL 2
Press desired button for two
seconds.
Momentarily press the « » button, then as soon as a
tone is heard or that the red LED lights-up, press the
desired button and hold it down for two seconds.
A command will not be executed if you do not press button long enough except for the RSS-2514XR remote that
immediately transmit when either the lock or unlock button is pressed. In that case, the command is sent at reduced power.
Only one command is transmitted even when a button is pressed for more than two seconds, except for the "Panic"
command, which is repeated as long as button is pressed.
Your system may be programmed in such a way that it can distinguish between two groups of remote controls (maximum:
two remotes per group). These groups let you activate predefined settings (seat, mirror and other) when unlocking certain
vehicles (additional optional equipment required).
BATTERY REPLACEMENT
Your remote works off two 3-volt lithium CR-2016 batteries or equivalent.
To replace the batteries, use a coin to snap open the remote casing via the slot on
the side of the remote, remove old batteries and replace them with new ones.
Make sure to properly replace the insulating strap around both batteries
and to properly orient the batteries; see illustration opposite.
Close the casing by applying a pressure on both parts while these are properly
aligned.
(2) CR-2016