Olson Technology OTRR-3000 - Manual (Page 3)

REV. X4 Page 3
SAFETY
Safety Precautions
The optical emissions from the units are laser-based and may present eye hazards if improperly used. NEVER USE
ANY KIND OF OPTICAL INSTRUMENT TO VIEW THE OPTICAL OUTPUT OF THE UNIT. Be careful
when working with optical fibers. Fibers can cause painful injury if they penetrate the skin.
Laser Safety Procedure
ALWAYS read the product data sheet and the laser safety label before powering the product. Note the operation
wavelength, optical output power and safety classifications.
If safety goggles or other eye protection are used, be certain that the protection is effective at the wavelength emitted
by the device under test BEFORE applying power.
ALWAYS connect a fiber to the output of the device BEFORE power is applied. Power should never be applied
without an attached fiber output. If the device has a connector output, a connector should be attached that is connected
to a fiber. This will ensure that all light is confined within the fiber waveguide, virtually eliminating all potential hazard.
NEVER look at the end of the fiber to see if light is coming out. NEVER! Most fiber optic laser wavelengths (1310nm
and 1550nm) are totally invisible to the unaided eye and will cause permanent damage. Shorter wavelengths lasers
(e.g. 780nm) are visible and are very damaging. Always use instruments, such as an optical power meter to verify light
output.
NEVER, NEVER, NEVER look into the end of a fiber on a powered device with ANY sort of magnifying device.
This includes microscopes, eye loupes and magnifying glasses. This WILL cause a permanent and irreversible burn on
your retina. Always double check that power is disconnected before using such devices. If possible, completely
disconnect the unit from any power source.
If you have questions about laser safety procedures, please call OLSON TECHNOLOGY INC. (OTI) before
powering your product.