Olson Technology OTPN-2000C - Manual (Page 2)

SAFETY WARNINGS
LASER RADIATION
The OTPT-300 laser transmitter emits invisible radiation that can cause permanent eye
damage.
. Operate the transmitter only with the
proper optical fiber installed in the transmitter optical connector. Power to the OTPN-
2000C should be turned-off or preferably, disconnected whenever the optical connector
cover is opened and there is no installed fiber (as when the fiber connector is being
installed or removed from the transmitter connector).
AVOID DIRECT EXPOSURE TO BEAM
NEVER
NEVER
NEVER
NEVER
USE ANY OPTICAL INSTRUMENT TO VIEW THE OUTPUT OF THE
LASER TRANSMITTER. “OPTICAL INSTRUMENT” INCLUDES MAGNIFYING
GLASSES, ETC.
LOOK INTO THE OUTPUT OF THE LASER TRANSMITTER
LOOK INTO THE OUTPUT OF A FIBER CONNECTED TO A LASER
TRANSMITTER.
LOOK INTO OR USE ANY OPTICAL INSTRUMENT TO VIEW THE
DISTANT END OF A FIBER THAT MAY BE CONNECTED DIRECTLY OR VIA AN
OPTICAL SPLIT, TO A TRANSMITTER THAT MAY BE OPERATING. THIS
SPECIFICALLY APPLIES TO FIBERS THAT ARE TO BE CONNECTED TO
RECEIVERS (SUCH AS THE OTPN-2000C) OR OTHER DEVICES AT ANY
DISTANCE FROM THE LASER TRANSMITTER.
HIGH VOLTAGE
FIRE HAZARD
SHOCK HAZARD
The power supply section (bottom section) of the OTPN-2000C contains no user
serviceable parts. There is exposed high voltage inside this section. Only factory
service technicians should open the power supply section.
The AC line input fuse is contained in the IEC 320 power input connector. This fuse is a
3AG, 0.5A, slow blow fuse. To avoid a risk of fire, this fuse should be replaced only with
an identically rated fuse.
The OTPN-2000C is designed for indoor use only. Direct exposure to moisture must be
avoided.