Olson Technology OTM-4000 (PAL I) - Manual (Page 6)

025-000336 REV X2 Page 6
B.) IF INPUT:
This indicates the preferred choice of the normal IF source. A rear panel input or an automatic transfer
could switch to the AUX IF input.
C.) CHANNEL PLAN:
This menu is not used with the OTM-4000 I, because this unit should be tuned by FREQUENCY
only.
D.) NAME:
This menu allows you to program the NAME that appears at the top of the normal (default) display.
Upper case and lower case letters as well as numbers and various symbols are available for use. Name
may be used to identify each modulator by function (channel, service, etc.)
E.) COMMAND MODE, BAUD RATE, and ADDRESS:
These functions are only used when the OTM-4000 I is configured with the optional remote
control feature.