Olson Technology OTEN-WC-01 - Manual (Page 5)

025-000503 Rev. X1 www.olsontech.com
5
Parameter Specification
Data Rate 10Mb/s to 2.5Gb/s. Both SFP modules used in the
converter must support the same data rate.
Standards Supports OC3, OC12, and OC48
Converter Power Requirement +5 Volts DC, 290mA (typical) using the
OTOLS-1312-30 SFP module.
Power Supply Voltage 100-240 Volts AC, 50-60Hz
Operating Temperature Range 0 to +50°C
Humidity 5-90%, RH Non-condensing
Weight 5.8oz. (160g)
Weight with two (2) SFP Mod-
ules
6.9oz. (195g)
Dimensions (L x w x H) 1.02” x 2.79” x 3.66” (26mm x 71mm x 93mm)
INSTALLATION
1. Attach a fiber cable from the converter to the fiber network. The fiber connections must match: transmit socket to re-
ceive socket.
2. Attach a UTP cable from the TP network device to the RJ45 port on the converter.
3. Connect the power cord to the converter and check that the Power LED lights up. The TP Act and FX Act LEDs will
light when all the cable connections are satisfactory.
NOTES ON THE CONVERTER
Features
• Interchangeable SFP modules allow for multiple fiber mode/type conversion options (single mode, multi-mode,
long-haul, short-haul, etc.)
• Compact size conserves space
• AC or DC power options
• Converts between dissimilar fiber modes and wavelengths
• Can use all standard MSA compliant SFP devices
Protocol-Independent
• Supports a full range of SFP modules offering various transmission speeds, from 10Mbps to 2.5Gbps
• Supports OC3, OC12, OC48
Maximizes Network Uptime
•
SFP Modules are hot-Swappable; no need to power-down chassis when upgrading or troubleshooting
• Troubleshooting features include diagnostic LED’s (Both SFP’s used in the Mode Converter must support the same
data rate.)
• Hot-swappable architecture Small Form Factor