Olson Technology OTDV-1250 - Manual (Page 6)

Model OTDV-1250, 025-000571 Rev. X5 6 www.olsontech.com
ETHERNET SPECIFICATIONS
Min. Typ. Max. Units
Number of Channels 1
Auto Negotiating 10Mb/s or 100Mb/s
ELECTRICAL, PHYSICAL, ENVIRONMENTAL SPECIFICATIONS
Min. Typ. Max. Units
DC Input Voltage 10 20 V
DC
(See Note 6)
DC Current 0.30 0.53 A (See Note 6)
Power 6 W (See Note 6)
Module Weight 25.4 oz.
Module Dimensions 11.5 x 6 (with base plate) x 1.25 inch
Operating Temp. Range 0 +50 °C
Storage Temp. Range -10 +60 °C
Humidity 5 90 %
NOTES:
1) The transmitter accepts either composite or S-Video input. If both are present, the S-Video signal will be used.
The receiver always presents both composite and S-Video outputs.
2) The output level will track the input level.
3) The standard transceiver model offers either two or four audio channels.
4) Input impedance is switch selectable by the user. The high impedance setting is single end input.
5) The data protocol is switch selectable by the user.
6) The OTDV-1250 utilizes high-efficiency switching power supplies internally. The power dissipation is nearly
constant as the input voltage changes. The highest current draw will occur at the lowest input voltage and vice
versa. Note that excessive noise and ripple on the power supply may degrade some of the performance parame-
ters.
7) All test results are at +25°C with a +15Volt DC power supply.
LED FUNCTIONS:
LED ID Description Green Red Orange Off
D1
Composite video
input present
Solid green when compos-
ite video present and no
S-video present. Slow
flashing green when com-
posite video present and
S-video present
N/A N/A
No Com-
posite
video pre-
sent
D2
S-video input pre-
sent
S-video present N/A N/A
No S-video
present
D3 Unit status Unit functioning properly
No opti-
cal signal
In or
missing
SFP
No optical
signal into far
end unit
No power
D4
Received video
present
Transmitter has valid video N/A N/A
No video at
transmitter