Olson Technology OTA-1000 - Manual (Page 3)

025-000429 REV A Page 3
The OLSON TECHNOLOGY OTA-1000 is a high performance, wideband, low noise, push-pull general purpose
amplifier with a built-in 90VAC to 240VAC power supply.
The OTA-1000 is completely self-contained and is configured in a small (2.5 x 2.7 x 1.5 inch) machined-aluminum
housing. Holes are provided for optional mounting as may be required and this unit is powered through an industry-
standard IEC-320 connector. A mating line cord is provided (USA standard 120VAC plug).
RF performance of the OTA-1000 is very good with CSO/CTB at >65dB below 77 output carriers at +40dBmV
and additional digital loading from 550MHz to 870MHz at 6dB below these 77 carriers.
The OTA-1000 has a –20dB output test point and has no adjustments for gain or tilt. Frequency response is <±
.75dB from 48MHz to 870MHz. Minimum gain to 1GHz is 22dB and this amplifier typically has a noise figure of
less than 4.5dB.
Possible applications of the OTA-1000 are many, including use on the test bench, as a laser transmitter driver,
distribution line or antenna amplification, etc.
INTRODUCTION