Installation, 1 introduction, 2 unpacking and inspection – Northern Airborne Technology TS9x User Manual
Page 7: 3 installation procedures, 1 warnings, 2 cautions, 3 cabling and wiring
SM51 Rev. 4.00
TS9x Series Lightweight Speaker Array Manual
Section 2.0 Installation
2.1 Introduction
Information in this section consists of: unpacking and inspection procedures, installation
procedures, post-installation checks, and installation drawings.
2.2
Unpacking and Inspection
Unpack the equipment carefully and locate the warranty card. Inspect the unit visually
for damage due to shipping and report all such claims immediately to the carrier
involved. Note that each unit should have the following:
- TS9x Lightweight Speaker Array
- Warranty Card
- Release certification
Verify that all items are present before proceeding and report any shortage immediately
to your supplier.
Complete the warranty card information and send it to NAT when the installation is
complete. If you fail to complete the warranty card, the warranty will be activated on
date of shipment from NAT.
2.3 Installation
Procedures
2.3.1 Warnings
Stand clear, this equipment operates at an intense sound level. Personnel must be kept
away from the direct loudspeaker beam.
2.3.2 Cautions
Do not operate the equipment in a hangar or in confined areas.
Do not operate the equipment with snow, water or other foreign matter in the
loudspeaker horn.
Do not clean the loudspeaker with compressed air.
2.3.3
Cabling and Wiring
All unshielded wire should be MIL-W-22759 or equivalent. For shielded wire
applications, use Tefzel MIL-M-27500 or MIL-M-81044 shielded wire with solder sleeves
Nov 12, 2003
Page 2-1
ENG-FORM: 805-0105.DOT
Amendment # 1
Mar 10, 2009
CONFIDENTIAL AND PROPRIETARY TO NORTHERN AIRBORNE TECHNOLOGY LTD.