Northern Airborne Technology LD12 - Manual (Page 11)

SM15 Rev. 4.00 LD12 Lamp Dimmer Manual
Nov 21, 2003 Page 2-1
ENG-FORM: 805-0104.DOT
CONFIDENTIAL AND PROPRIETARY TO NORTHERN AIRBORNE TECHNOLOGY LTD.
Section 2.0 Installation
2.1 Introduction
Information in this section consists of: unpacking and inspection procedures, installation
procedures, post-installation checks, and installation drawings.
2.2 Unpacking and Inspection
Unpack the equipment carefully and locate the warranty card. Inspect the unit visually
for damage due to shipping and report all such claims immediately to the carrier
involved. Note that each unit should have the following:
- LD12 Lamp Dimmer
- Warranty Card
- Release certification
Verify that all items are present before proceeding and report any shortage immediately
to your supplier.
Complete the warranty card information and send it to NAT when the installation is
complete. If you fail to complete the warranty card, the warranty will be activated on
date of shipment from NAT.
2.3 Installation Procedures
2.3.1 Warnings
Do not bundle any lines from this unit with transmitter coax lines. Do not bundle any
logic or DC power lines from this unit with 400 Hz synchro wiring or AC power lines. Do
not position this unit next to any device with a strong alternating magnetic field such as
an inverter, motor or blower.
2.3.2 Cautions
Do not install the LD12 without making a suitable amendment to the flight manual
indicating how the NAV annunciation and dimming/ test functions have been
implemented in the aircraft.