Dixon 422 User Manual
Page 7
ELECTRICAL SYSTEMS
Keep all connections clean and tight. Maintain the fluid
in the battery at correct level.
BODY
The body may be washed with a mild detergent and
waxed with any automotive type wax.
TRANSAXLE
For adjustment or repair confer with authorized
Dixon dealer service department. Adjustment or
repair by other than authorized dealer voids
warranty.
SPARE PARTS
See your dealer for ordering spare parts or
warranty service.
INSTALLING AND REMOVING MOWER DECK FROM FRAME
1. Attach stabilizer arms to mower deck with pins and
clips-as shown on drawing.
2. Attach the ½ “ dia. engaging rod with a rollpin
through the engaging cam.
3. Position the drive belt on pulleys.
4.Place mower deck under unit in approximate
operating position with engaging rod through hole in
the floor.
5. Connect drive belt to lower engine pulley, being
certain that belt is inside of belt guides. Loosen belt
keeper by loosening the two rear engine mount
bolts; this will allow belt to be placed on motor pulley.
Retighten engine mount bolts.
6. Attach lift linkage to mower deck on the inside of the
attaching lugs as shown on drawing with pins and
clips. (4 places)
7. Attach stabilizer arms to pivot point on the inside of
attaching bracket with pins and clips.
8. Place engaging handle on engaging rod and fasten
with bolt and locknut.
9. Connect pan wire loom plug to plug on frame wire
loom. Mower will not start unless this connection is made.
10. After installing pin clips, rotate pins so that open end of clip
is down.