Norpole EWCIM350S - Manual (Page 12)

12
EN - 12
CLEANING AND MAINTENANCE
7. Wipe down the interior of the water sump with the de-scaling solution and warm water. Rinse
thoroughly with clear water.
8. Reassemble the sprinkler arm, evaporator and block water board.
9. Perform steps 1, 3-5 of the Ice Making System Cleaning procedure detailed below.
1. Unplug the ice maker ensuring the water connection remains intact.
2. Open the door of the top cabinet, and making sure there are no ice cubes on the evaporator,
remove all ice cubes from the ice storage bin.
3. Remove the water box and dispose of any water before reinstalling. Then, fill the ice maker cleaner
into the water box. Plug in the unit and press the clean button (5 seconds). The machine will
automatically go into cleaning mode which lasts for 30 minutes. At the same time, clean the ice
storage bin with the cleaner.
4. After the ice maker completes the cleaning mode, remove the water box, drain the water, clean the
water box and evaporator cover according to the instructions in this manual (see step 6 below).
Lastly, reinstall the water box, press the clean button (5 seconds) to begin the water cycle mode
and clean all residual cleaning solution.
5. Repeat the process detailed in step 4 three times to ensure the cleaning solution has discharged
completely.
6. After completing step 5, remove the water box and evaporator cover. Clean these parts with water
between 95-122°F (35-50°C). Flush and clean the inner liner of the ice storage bin.
7. Once you have completed the above processes, throw away the ice cubes.
Ice Making System Cleaning