NIStune Type 3 - Manual (Page 7)

Type 3 Hardware Installation Manual Page 6 of 12
2. CHANGE ECU JUMPER SETTINGS
Jumpers are used on the ECU to tell the microcontroller to read from either factory code (located in a
memory chip on the ECU main board) or from the Nistune daughterboard. You will need to move the
jumper on the ECU so that it will read from the Nistune board
The easiest way to move the jumper is to melt the solder on both ends at once by using the de-soldering
iron one end and soldering iron the other. The jumper may be replaced with a small piece of wire if you
want. Jumpers are on the rear of the ECU mainboard in most cases.
Model Name Engine ECU Series Jumper
S13 180SX SR20DE, DET 52Fxx, 50Fxx CJ1 > CJ2
S13 240SX KA24DE 53Fxx, 54Fxx, 59Fxx CJ1 > CJ2
W10 Avenir SR20DET 95Nxx CJ1 > CJ2
U12/13 Bluebird SR20DET/KA24DE 79Exx, 1E0xx, 4E6xx, 3E6xx, 1E4xx CJ1 > CJ2
S14 Silvia (early) SR20DET 69Fxx, 74Fxx, 75Fxx J011 > J010
64Yxx, 67Yxx, 70Yxx, 71Yxx, 78Cxx CJ1 > CJ2
B13 Sentra/NX2000 SR20DE
94Yxx CJ1 > CJ2
N14/15 Pulsar SR18DE, SR20DE 58Yxx, 68Cxx, 1N960 CJ1 > CJ2
RNN14 Pulsar GTiR SR20DET 54Cxx, 69Cxx CJ1 > CJ2
45Pxx, 51Pxx, 52Pxx CJ1 > CJ2
Z32 300ZX late VG30DE(TT)
53Pxx J001 > J002
J30 Maxima VE30DE 97Exx CJ1 > CJ2
62Jxx, 70Jxx, 71Cxx, 77Jxx, OJ26x,
OJ27x CJ1 > CJ2
P10 Primera SR20DE
83Jxx CJ1 > CJ2