Nevion AD6464M User Manual
Page 11

AD6464M / AD128128M
Rev. 7
nevion.com | 11
3.4.3 Status LEDs and Reset button
There are 4 LEDs on the front side of the Multicon VX-MOD-SM card, and a reset button on
the rear side.
Status LEDs
The LEDs indicate the following:
Diode
Red LED
Yellow LED
Green LED
No light
Status
Card error.
Not applicable.
Overall status of
the card is OK
Card has no
power, or is not
inserted correctly.
Eth
Not applicable.
Full duplex
connection.
Half duplex
connection.
No Ethernet link
established; check
cable.
Warn
Abnormal situation:
no functional error,
but a situation that
requires attention.
See also chapter 6.
Not applicable.
Normal situation.
Not applicable.
Load
High load
6
on the
µController. May
occur during
system start up and
software
reconfigurations / -
upgrades.
Medium load on
the µController.
Low or normal
load on the
µController.
Not applicable.
6
Red LED means 100% load on the Multicon. This may occur for intervals up to approximately 20
seconds. Longer periods may indicate that there is something wrong with the Multicon.