Nevion SL-D32P+ - Manual (Page 26)

SL-D32P+ Rev. F
nevion.com | 26
Appendix B
Additional Protocol information
B.1 Leitch Pass-Through protocol
This protocol is available in Sublime firmware 2.4.0 and later.
The Sublime implementation of Leitch Pass-Through supports all commands described in
"Leitch Routing Switchers Serial Protocol Reference, Edition E".
In the command "Alarms Status Request", a bit-field is used for reporting active alarms. In
Sublime, the bit-field is used as in the table below.
Bit Description Reported from firmware version
0 Power A failed 2.4.0
1 Power B failed 2.4.0
2 Positive power too low 2.4.0
3 Negative power too high 2.4.0
4 Client TCP/IP connection failed 2.4.0
5 No valid product key 2.4.0
6 SFP error 2.4.0
7 EXT IN not locked 2.5.4
8 EXT IN CRC error counting 2.5.4
9 Fan error 2.6.2
B.2 Grass Valley Native protocol
This protocol is available in Sublime firmware 2.5.4 and later.
Sublime does not support all commands available in this protocol. The supported
commands are described in the table below.
Command Parameter Comments
BK - Background
Activities E - Echo BK,E and BK,E,ON and BK,E,OFF are
all accepted and will be responded with
ER,00,BK.
R - Protocol Processor
Software Revision # Will be responded with KB,R,version>,
TJ - Request
Take Index With
Level Bitmap Each command supports only one X-
point.
TI - Request
Take Index With
Level Index The optional level Index is not supported.
The command can only be used to
switch all levels.
QH - Query
alarm status AC - Query active
alarm status Sublime has defined the alarms defined
in the table below. All active alarms will
be responded on this request.
Alarm
ID
Alarm Name Alarm
Parameter
0x0101 Frame Fan Fan number
0x0105 Power-supply 01 - Power A
failed
02 - Power B
failed
0x010A Positive power
too low
Always 00
0x010B Negative
power to high
Always 00