Nevion ADC-SDI-CC - Manual (Page 14)

ADC-SDI-CC Rev. 3
DATE: 23 July 2008
Network Electronics AS, P.O.Box 1020, N-3204 Sandefjord, Norway. Tel.: +47 33 48 99 99 – Fax: +47 33 48 99 98
E-mail: [email protected] – Web: http://www.network-electronics.com/
Technical specifications are subject to be changed without notice.
14
Here xxxx denotes the source and destination rack and slot coordinates, while X represents a version
number. As of primo July 2004, these revisions would be:
xxxxADC-SDI-CC\
PIC sw rev 1.0.2\
FPGA sw rev 6\
Protocol ver 1.0
6.3 The “info” command
This command report the entire state of the card. An example:
xxxxCVBS\
Locked 50Hz\
Field 1 mark on\
Comb on\
Pedestal on
Status of Status string Comment
CVBS CVBS is selected
Svideo Svideo is selected
YpbPr YPbPr is selected
Input Select
RGB RGB is selected
Locked 50Hz Locked to 625 lines 50 Hz.
Locked 60Hz Locked to 525 lines 60 Hz.
Not locked 50Hz Not locked, previously locked to 50Hz.
Analogue input.
Not locked 60Hz Not locked, previously locked to 60Hz.
Field 1 marking on The Mark Field 1-feature is turned on. Field 1 marking
Field 1 marking off The Mark Field 1-feature is turned off.
Comb on Comb filter selected. Chroma filter
Comb off Chroma trap filter is selected.
Pedestal on Pedestal present is selected. Pedestal
Pedestal off Pedestal not present is selected.
Table 6: The info command broken up in components.
The “info” command is composed by many minor lines, fully specified in table 6. In general, when a
condition is normal, it is not reported. For instance, pedestal is reported when locked to 50Hz, even tough
the setting has no effect on the video.
6.4 Video modes commands.
The CVBS, RGB, Svideo and YPbPr commands sets the video input mode. Remember that RGB -mode
needs separate sync on the CVBS/Luma channel. This sync may be a synchronous CVBS-signal.