5 configuration, 1 stand-alone mode, 2 multicon gyda mode – Nevion Flashlink Compact II User Manual
Page 19: 1 address setting, 5configuration
Flashlink Compact II
Rev. A
nevion.com | 19
5
Configuration
Flashlink Compact II can operate in two modes, Stand alone and Multicon Gyda controlled
mode. This setting is set by switch 8 on the back of the Flashlink Compact II.
5.1 Stand-alone mode
The Flashlink Compact II is configured to transport SD/HD/3G-SDI with reclocked set to
auto.
Switch 1 to 7 has no function in this mode.
5.2 Multicon Gyda mode
In this mode configuration can be done by Multicon Gyda. Each of the converter boards in
the Flashlink Compact unit will come up as separate Flashlink cards in Multicon. The frame
and slot address is setup by dip switches 1 to 7. Each slot must be set to a unique sub-rack
and slot address.
In order to ensure proper operation of the system, it is important that no sub-
racks or Flashlink Compact II controlled by the same Multicon Gyda have the
same address set.
5.2.1 Address setting
The switches 1-3 set the sub-rack address:
SW1
SW2
SW3
Sub-rack
OFF
OFF
OFF
0
ON
OFF
OFF
1
OFF
ON
OFF
2
ON
ON
OFF
3
OFF
OFF
ON
4
ON
OFF
ON
5
OFF
ON
ON
6
ON
ON
ON
7