Specifications – MultiDyne RGB-5000 Series User Manual
Page 7
Instruction Manual, RGB5000 FTX/FRX
3BSPECIFICATIONS
7
SPECIFICATIONS
General:
Video Scan Rates:
15KHz -127KHz horizontal, 40Hz -130Hz vertical
Video Standards supported:
RGBHV, RGBS, RGsB, VGA, SVGA, XGA, SXGA,
WXGA, WUXGA with TTL H and V syncs; Sun or Apple
with TTL composite sync; Silicon Graphics with Sync-
on Green; RGB HDTV 480i, 480p, 720p, 1080i or
1080p with TTL sync, YPrPb HDTV 480I, 480P, 720P
or 1080i with sync on Y including 3-level sync.
Video Resolutions Supported:
1920x1200 @ 60
Higher resolutions and/or refreshes supported with
some loss of sharpness
Video Signal to Noise Ratio:
>60dB
Audio Signal to Noise Ratio:
TBD
Fibers:
1 fiber, 62.5/125um Multimode (-2); 8.3/125um
Singlemode (-50/52)
Fiber Connector Type:
ST
Wavelengths:
1310 and 850nm (-2); 1310 and 1550nm (-50/52)
Optical Budget:
6 dB (-2), 8 dB (-50), 13 dB (-52)
Maximum Transmission Distance:
200m (-2), 2km (-50) 15km (-52)
Operating Environment:
0 – 50 degrees C
Transmitter, RGB5000-FTX-2/50/52:
Video Input/Output Connectors:
1 HD-15 VGA plus 1 HD-15 VGA loop thru for local
monitor.
Video Input Impedance:
75 ohms (internal termination automatically removed
when Local Monitor is plugged in)
Video Input Level:
700mv p-p not including sync, if present on green
Audio Input Connector :
1, 3.5mm Stereo jack
Audio Input Level:
Line level, not to exceed +4dB
Audio Input Impedance:
>10k
Optical Output Power:
-9 dBm (-2), -10 dBm (-50) or –5 dBm (-52)
Power Requirement:
5 VDC @ 1.6A
Receiver, RGB5000-FRX-2/50/52:
Optical Input Sensitivity:
-15 dBm (-2) or –18 dBm (-50/52).
Video Output Connector:
1 HD-15 VGA.
Video Output Impedance:
75 ohms
Video Output Level:
700mv p-p not including sync, if present on green
Audio Output Connector:
1 3.5mm Stereo Jack
Audio Output Level:
Unity Gain with respect to FTX
Audio Output Impedance:
< 100 Ohms
Power Requirement:
5 VDC @ 800mAmps
.
Specifications subject to change without notice.