Mr. Coffee BVMC-KG5 - Manual (Page 7)

Cleaning and Emptying the Reservoir
Discard the remaining water by removing the reservoir
lid and turning reservoir upside down over the sink. It is
recommended to empty the water reservoir between uses
and use fresh water for each brew. Do not immerse appliance
in water.
Storage
Empty the reservoir before storing and take care to ensure that
you store your Brewer in a safe and frost free environment.
It is suggested to store your Brewer in the upright position. If
you store the Brewer in a cold environment, you run the risk of
condensation freezing inside the Brewer and causing damage.
When you prepare to use it after storage, we recommend
wiping the reservoir with a damp lint-free cloth and running
three cleansing brews without a K-Cup ® pack.
If your Brewer has been in an environment below freezing,
please be sure to let it warm to room temperature for 2
hours before using.
De-Scaling Your Brewer
Mineral content in bottled or filtered water varies. Depending
on the mineral content of the water, calcium deposits or
scale may build up in your Brewer. Scale is non-toxic but left
unattended, it can hinder Brewer performance. Descaling
your Brewer helps maintain the heating element, and other
internal parts of the Brewer that come in contact with water.
The Brewer should be de-scaled every 3-6 months to ensure
optimal performance or when there are white deposits in the
reservoir. It is possible for calcium deposits to build up faster,
making it necessary to de-scale more often.
the top of the K-Cup ® pack Holder with one hand while
pushing up on the bottom of the K-Cup ® pack Holder from
underneath with the other until it releases. After cleaning,
align the K-Cup ® pack Holder with the opening using the
two front ribs as a guide, and snap into place from the
top.
2. Cleaning the Funnel – The Funnel can be removed from the
K-Cup ® pack Holder by pulling on it until it snaps off (fig.
1). The Funnel is dishwasher safe. To replace it, just snap it
back onto the K-Cup ® pack Holder Assembly.
3 Cleaning the Exit Needle – The Exit Needle is located on
the inside bottom of the K-Cup ® pack Holder Assembly.
Should a clog arise due to coffee grinds, it can be cleaned
using a clean household tool. Remove K-Cup ® pack
Holder assembly and detach Funnel.
Insert the household tool into the
Needle to loosen the clog and push
it out. The K-Cup ® pack Holder is
dishwasher safe.
CAUTION:There are sharp
needles that puncture the
K-Cup ® pack above the
K-Cup ® pack Holder and in
the bottom of the K-Cup ®
pack Holder. To avoid risk of
injury, do not put your fingers
in the K-Cup ® pack Assembly
Housing.
!
FIGURE 1
12 13
BVMC-KG5_11ESM1.indd 13-14 1/30/13 11:05 AM