Mr. Coffee BVMC-EL1 - Manual (Page 14)

English 13
PROBLEM POSSIBLE CAUSE SOLUTION
COFFEE IS LEAKING
FROM THE
APPLIANCE.
The brew basket is not
positioned properly.
Make sure the brew basket is
inserted properly.
WATER IS LEAKING
FROM THE
APPLIANCE.
Too much water was poured
into the water reservoir.
Pour only 1 cup of water into the
reservoir and do not exceed the
overfill hole located in the back of the
reservoir.
THE LATTE PITCHER
DOES NOT FIT INTO
THE BASE.
The orientation of the latte
pitcher is not correct.
The pitcher must be secured onto the
power connector with the pitcher
handle facing outwards.
The on/off lever is lowered
blocking the entry.
Make sure the on/off lever is raised into
the off position to allow proper
clearance for the pitcher.
THE COFFEE DOES
NOT DISPENSE FROM
THE CHAMBER.
The selector switch is lowered
to the heat/froth option.
Lift the selector switch for
latte function.
TROUBLESHOOTING YOUR CAFÉ LATTE
Your MR. COFFEE
®
Coffeemaker has been carefully designed to give you many years
of trouble-free service. In the unlikely event that your new coffeemaker does not
operate satisfactorily, please review the following potential problems and try the steps
recommended BEFORE you call an Authorized Sunbeam Service Center.
Do you still have questions? You can call us toll-free at the MR. COFFEE
®
Products
Consumer Service Department, 1-800-MR COFFEE (1-800-672-6333) or you can visit us
at www.mrcoffeelatte.com.